|
This is a replacement for USB-FPGA Modules 2.13a
- High-Speed (480 MBit/s) USB interface via Mini-USB connector (B-type)
- Cypress CY7C68013A EZ-USB FX2 Microcontroller
- Artix 7 XC7A35T FPGA, Speed grade 1C
- External I/O connector (consisting in two female 2x32 pin headers with 2.54mm grid) provides:
- 100 General Purpose I/O's (GPIO) connected to FPGA
- JTAG signals
- Reset signal
- External power (4,5 V .. 16 V) input
- 3.3V output
- I/O voltage output or input
-
256 MByte DDR3 SDRAM:
- Up to 400 MHz clock frequency
- 16 Bit bus width
- Up to 1600 MByte/s data rate
- Usable with the Xilinx Memory Interface Generator (MIG), examples are included in the SDK
- 128 MBit on-board Flash memory
- Allows Bitstream loading from Flash to FPGA (up to 16.5 MByte/s)
- Accessible from EZ-USB FX2 and from FPGA, but not while the EZ-USB FX2 GPIF/FIFO interface is in use
- Unique non-erasable ID which can be used to generate a serial number
- Fast FPGA configuration via USB with up to 24 MByte/s
- 128 Kbit EEPROM memory (can be used to store the EZ-USB firmware and board settings)
- On-Board power supply:
- 3.3 V: 2000 mA
- 1.8 V: 2000 mA
- 1.5 V: 2000 mA
- 1.0 V: 2000 mA
- Optional:
- Battery to store a key for bitstream encryption
- On-board JTAG connector
- Temperature range: 0-70°C (board), 0-85°C (FPGA)
- Usable with free Xilinx Vivado and ISE Webpack
- Powerful Open-Source SDK with many examples
|
