• High-Speed (480 MBit/s) USB interface via Mini-USB connector (B-type)
• Cypress CY7C68013A EZ-USB FX2 Microcontroller
• Artix 7 XC7A100T FPGA, Speed grade 2C
• External I/O connector (consisting in two female 2x32 pin headers with 2.54mm grid) provides:
  • 100 General Purpose I/O's (GPIO) connected to FPGA
  • JTAG signals
  • Reset signal
  • External power (4,5 V .. 16 V) input
  • 3.3V output
  • I/O voltage output or input
• 256 MByte DDR3 SDRAM:
  • Up to 400 MHz clock frequency
  • 16 Bit bus width
  • Up to 1600 MByte/s data rate
  • Usable with the Xilinx Memory Interface Generator (MIG), examples are included in the SDK
• 128 MBit on-board Flash memory
  • Allows Bitstream loading from Flash to FPGA (up to 16.5 MByte/s)
  • Accessible from EZ-USB FX2 and from FPGA, see the CPLD description
    
• Fast FPGA configuration via USB using CPLD: up to 24 MByte/s
• 128 Kbit EEPROM memory (can be used to store the EZ-USB firmware)
• 2 Kbit MAC-EEPROM: contains a unique non erasable MAC-address and is used to store firmware settings
• On-Board power supply:
  • 3.3 V: 2000 mA
  • 1.8 V: 1000 mA
  • 1.5 V: 2000 mA
  • 1.0 V: 4000 mA
• Heat sink for high performance / high speed applications, see Section heat sink
• Optional:
  • Battery to store a key for bitstream encryption
  • On-board JTAG connector
• Temperature range: 0-70°C (Board), 0-85°C (FPGA)
• Usable with free Xilinx Vivado and ISE Webpack
• Powerful Open-Source SDK with many examples

Package contents:

• FPGA Board
• 1 passive heat sink
• 2 thermal pads